1/8” NPT brass threads. Must be installed without use of Teflon tape or other sealants in order to insure good ground for proper operation

Replaces mechanical speedometer cable at transmission

Replaces mechanical speedometer cable at transmission

Part # 8941 Oxygen Sensor

Installs in exhaust system to provide signal for Cyberdyne Air/Fuel gauge

Replaces stock oil pressure sender. 1/8” NPT brass threads. Must be installed without use of Teflon tape or other sealants to insure good ground for proper operation

Install away from engine or other heat sources for proper operation

Install on bolt or screw located close to heat source to be monitored

Part # 3306 Large Mounting Cup

Fits Cyberdyne 3 3/8” Speedometer and Tachometer

Part # 3307 Small Mounting Cup

Fits all Cyberdyne 2 1/16” gauges

Part # 9901 Speed Calibration Box

Use for speed calibration with Cyberdyne mini-speedo

Part # PO401 Single Gauge Mounting Pod

Part # PO402 Double Gauge Mounting Pod

Fits Cyberdyne 2 1/16” gauges

Part # PO403 Triple Gauge Mounting Pod

Fits Cyberdyne 2 1/16” gauges